I converted to AAJ discs. Used a 1976 Dart dual master cylinder. No
leaks anywhere.
I bench bled the master cylinder best I could.
I bled the brakes using a hose and check valve into a jar of brake
fliud. This works on all my other vehicles. I ran quite a bit of
fluid through to make sure.
Brake pedal goes straight to floor but will pump up quickly and hold
pressure. As soon as I let up and pedal comes all the way to the TOP
the brakes are gone again and need to be pumped. If I just let up a
little I don't lose them.
I then gravity bled them all for a few hours.. Two rears at same
time , then two front at same time.
Still get the same result.
I thought I read something about the Dart M/C losing pressure
somehow? Or, is it air in m/c? Bad m/c?
Any advice is great ... I would loooove to drive this car oneday.
--
--
Please address private mail -- mail of interest to only one person -- directly to that person. That is, send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks!
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
Back to the Home of the Forward Look Network