Re: front window vent question

["Gary H." <62to65mopar@xxxxxxxxxxx>]

http://1962to1965mopar.ornocar.com/temp/vent-window-1.jpg 
and
http://1962to1965mopar.ornocar.com/temp/vent-window-2.jpg

Are pictures that show what I'm looking at.  I guess you are saying to use a thick end screwdriver and work the stud back and forth or counterclockwise? 

Thanks,
Gary H. 

>  -------Original Message------- 
>  
>  The pin is pretty simple to remove - finish nail, etc to punch it out.
>  
>  However, it seems to me that once you get the handle off, the end of the stud
>  has a slot in it for a flat blade screw driver.  Seems that was a pretty snug
>  fit. (corrosion?) Get the right width and thickness blade before you go at it.
>  
>  
>  Akron Don Gallimore 

-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.