Re: Car stalls when I hit the brakes

[John deVries <corneliusdevries@xxxxxxxxx>]

Are you able to stop it from stalling by pushing the gas pedal when you brake. Had a mg with a loose wire on the starter cutting power when I stopped. 

Sent from John

On Nov 19, 2012, at 11:38, Eric R <hoodoovoodooray@xxxxxxxxx> wrote:

Thanks for the video and responses.

 

I set the float  correctly, too high,  too low , way  too high and a bit low and no matter where it sets it  stalls when I hit the brakes going forward and not backwards.

 

Could a semi-faulty fuel pump   cause this?   Maybe it  reverse fuel  dumps in past the needle when I hit the brakes letting it stay running?

 

 

 

On Monday, November 19, 2012 1:52:34 PM UTC-5, 62to65mopar wrote:

View http://youtu.be/9qgBfgz1rz8 -- that should help.

Thanks,
Gary H.


>  -------Original Message-------
>  From: Eric R
>  Hi,
>  
>  Too  low as when measuring  how far down they hang in relation to the edge
>  of  carb top?   Move them up a tiny bit so they don'thang down as far?  Low
>  would seem  to  shut needle sooner if I can imagine howit works in my
>  head.
>  
>  

--
--
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.
 
 
 

--
--
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.