On Mar 1, 5:49 am, Jason Rhoades <
Ja...@xxxxxxxxxxxxx> wrote:
> Do you gave a good insulator between the carb and intake? I didnt at first and boy was it hard to start. Put a spacer in made for insulating the carb from the heat. Problem solved. For me may not be the same for you.
> Jason
>
> Sent from my Motorola ATRIX™ 4G on AT&T
>
>
>
>
>
>
>
> -----Original message-----
> From: Cory Rempel <
cory_...@xxxxxxxxxxx>
> To: "
1962to1965mopars@xxxxxxxxxxxxxxxx" <
1962to1965mopars@xxxxxxxxxxxxxxxx>
> Sent: Fri, Mar 1, 2013 10:56:21 GMT+00:00
> Subject: Hard Starting
>
> Well spring is coming and I was thinking about an annoying little I'm having with my Polara. Actually my buddy is having the same problem too. We both have recently rebuilt 440's in our cars. His a 71 300, mine 65 Polara. His block is like a 75 mine is a 70. After driving our cars around for a bit, we still have to pump the ever living shit outta them to get them started again. I got a 750 Eddy on the stock intake which I'm gonna put my Eddy Torker 2 intake on it this spring. Why do I have to pump it so much even when it's warmed up?
> The reason I mentioned my buddy's car is that he also has a 70 Satellite with the exact same engine, minus the rebuild. He said he swapped the carbs between the 300 and the Satellite and it didn't make any difference. The Satellite started like it was fuel injected and his 300 you pump the hell out of it. So its not a carb problem, as we're both running all fairly new Eddy 750's on our cars.
> Could it be the ignition system, distributor, bad coil, what? In my car, being low mileage rebuild with a mild cam (a couple steps above the stock cam), it's not a compression issue. I know it's still about two months away until the beast is on the road again, but anybody got any ideas for the very near future. Thanks in advance.
> Cory Rempel
> 65 Polara 440/727
>
> PS If anybody's gonna say I should go with a Holley carb, save your breath. If I'm going to change the induction system, I'm going to put an EFI throttle body kit on it when I have saved enough. Until then I'll stick with my Edelbrock, thank you.
>
> --
> --
> --
> Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
>
>
> ---
> You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
> To unsubscribe from this group and stop receiving emails from it, send an email to
1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx.
Back to the Home of the Forward Look Network