I was looking at past posts about progressive linkage for the 2 4's on the 318 poly. Due to the larger center spacing of the poly dual quad intake the Eldenbrock progressive linkage will not work. The short rod in the kit is to short. Some posted they ordered two kits and used the longer rods from the two to make one linkage. I called Eldenbrock about this. They have the kit made for them by Enderle Fuel Injection 1830 Voyager Ave
-- Simi Valley, CA 93063 (805) 526-3838. I called them. They will put the longer rods in the kit so you only have to buy one kit. Or if you had bought one from Eldenbrock like I did. They will sell just the longer rod. Sent from John -- -- Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks! 1962 to 1965 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. -- You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group. http://groups.google.com/group/1962to1965mopars?hl=en. --- You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group. To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxxx For more options, visit https://groups.google.com/groups/opt_out. |
Back to the Home of the Forward Look Network