Points/Ballast Resistor Gurus Needed!

[Donald Gallimore <dongallimore@xxxxxxx>]

'65 Satellite 383 points distributor.

Up until a few minutes ago, the engine would not when the key was on START.  It 
would ocassionally catch as the key was released - gonna guess the motor was 
rotating and was ready to fire when the key hit the RUN position. I check the 
circuit from IGN2 on the switch to the ballast resistor and everything has 
continuity. So now all of a sudden it starts on START. Maybe the electrical 
contact cleaner did it's job along with the sliding contacts against each other 
as I disconnect and reconnect the wiring. 

But, now I have another problem - it starts on START but won't run when the key 
is released.  Typically this is the ballast resistor but I've checked and it 
still has continuity. 

What happened??? What do I check now?
 
Akron Don Gallimore

-- 
-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

--- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxxx
For more options, visit https://groups.google.com/groups/opt_out.