Re: Pull engine with transmission attached?
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Pull engine with transmission attached?



I'm willing to wager a complete engine and trans weighs more than the front end of an early B body. If anyone is concerned about the cherry picker giving out, it would do more damage to a car if the entire engine assembly were to drop from 5 foot in the air on to front end of the car than the car body itself dropping. 

I use a 6' chain with hooks on each end and insert them in the 1 ½" holes on the bottom of the frame rails near the rad support. No need to pull the grille, bumper, splash pans, etc. 

@ Jim Jablonski:

Jim, since the bumper was off your car a quick way to rig the front of your car is to run a bolt through each end link of about 4' length of chain, then through the ends of the frame horns. 



On Friday, November 11, 2016 at 12:55:16 AM UTC-5, dennis.1963ply wrote:
Hello,

I'm going to be pulling the engine and transmission out of my 64 Belvedere.

When I pull the 383 and 4-speed transmission out of my 64 SF I can pull them together.  Can I do the same with my 64 that has a 318 Poly and 727 automatic?  I need to work on both the engine and transmission.

Thanks
Dennis C.

--
--
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

---
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx.
For more options, visit https://groups.google.com/d/optout.


Home Back to the Home of the Forward Look Network