Re: Pull engine with transmission attached?

Thanks,

I have a cherry picker type lift and have pulled the engine and transmission from my 64 SF, 383 4-speed with it a number of times. As for the hood I drilled about 1/8" holes through the hood hinges into the hood as locators. When I put the hood back on I just line up the holes slide a drill bit in the hole to keep the alignment and bolt it on. The only caution on drilling the holes is to put something on the drill bit when drilling the holes so the bit does not go through to the hood.

To everyone thanks for all of the good suggestions. I have a stack of parts from Gary P. that need to go in the engine and the transmission needs a little work. I'm going to try to get it done this winter.

Taking the engine and transmission out the bottom looks interesting however after the engine and transmission are out I will need to be able to move the car out so it needs to stay on all 4 wheels.

Thanks again to everyone
Dennis C.

On Saturday, November 12, 2016 at 5:19:36 PM UTC-7, TopBanana wrote:

If you don't have a lift, pull them together. You can certainty drop the whole thing out the bottom but that means taking apart your front suspension and you'll likely need a lift to pick the car over the engine/trans/k-frame/suspension.

Bottom line out the top as a unit is a tried and true method.

Make sure you mark the hood location for pulling it off for easy installation and alignment.

Bill M

On Nov 11, 2016 12:55 AM, "dennis.1963ply" <dennis....@xxxxxxxxx> wrote:
Hello,

I'm going to be pulling the engine and transmission out of my 64 Belvedere.

When I pull the 383 and 4-speed transmission out of my 64 SF I can pull them together. Can I do the same with my 64 that has a 318 Poly and 727 automatic? I need to work on both the engine and transmission.

Thanks
Dennis C.

--
--
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

---
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopa...@googlegroups.com.
For more options, visit https://groups.google.com/d/optout.