I am reposting this email for Mike as it went astray. Please help if you can. I assume it is 1965 Plymouth B-body exclusively. Thanks, Gary H. > -------Original Message------- > From: Michael LeFevre > Subject: Front bumper/splash shield clearance. > Sent: Jun 06 '17 17:40 > > Hi fellas and gal, > I need a favor. I have cut out the license plate area of my 65 > Belvedere and welded in a flat piece of steel which I cut two 4" > openings in for driving lamps .I am ready to fabricate mounts for them > but, It has been 9 years since I disassembled the car and I can't > remember how the splash shield fits in with the bumper and do not want > to interfere with the fitment. Would it be possible for one of you > members to provide me with a photo of the rear of the bumper showing > how the splash shield fits with the bumper? Thanks! > Mike -- -- -- Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks! 1962 to 1965 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. -- You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group. http://groups.google.com/group/1962to1965mopars?hl=en. --- You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group. To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx. For more options, visit https://groups.google.com/d/optout.