|
|
Extreme Veteran
Posts: 375
Location: milano, italy | Hello
I am trying to determine shape and location of the ballst resistor for my 58 Plymouth Belvedere Golden Commando. The wiring would suggest a inner fender location, but am curious to see a correct location. Also, the shape of the ballast should be different from what has been used in later years. Thank yu for the help |
|
|
|
Expert
Posts: 2996
Location: Sept. 1958 | Should be off the right side lower master cylinder stud. |
|
|
|
Expert
Posts: 1906
Location: Ontario, Canada | My patterns indicate the resistor is mounted at the master cylinder for poly engines and at the regulator for B engines.
Greg
(image.jpg)
Attachments ---------------- image.jpg (83KB - 206 downloads)
|
|
|
|
Expert
Posts: 1906
Location: Ontario, Canada | Or this one. There is quite a difference in the engine wiring harnesses between poly and B engines.
Greg
(image.jpg)
Attachments ---------------- image.jpg (163KB - 209 downloads)
|
|
|
|
Extreme Veteran
Posts: 375
Location: milano, italy | Greg...i am using your wiring...so i am pretty sure the location should be on the inner fender. the ballast is same as in the pics. i was just wondering where the ballast would be mounted...as there are no ectra holes in the inner fender |
|
|
|
Expert
Posts: 2996
Location: Sept. 1958 | Here's a photo from a 58 Fury GC car. Resistor is not the correct type.
Edited by christine-lover 2016-07-01 6:02 PM
(image.jpg)
Attachments ---------------- image.jpg (97KB - 217 downloads)
|
|
|