|
|
Veteran
Posts: 171
Location: New Richmond, WI | Any one know where I can find this linkage? Are there reproduction options out there or another vehicle that uses similar linakge? This is the push rod for the carb. Thanks
(I-03_2008-12-02_Final_Dual_Quad_Carb_Link.jpg)
Attachments ---------------- I-03_2008-12-02_Final_Dual_Quad_Carb_Link.jpg (75KB - 88 downloads)
|
|
|
|
Expert 5K+
Posts: 7809
Location: Williams California | What application is this linkage for? Vehicle type?
---John |
|
|
|
Veteran
Posts: 171
Location: New Richmond, WI | It will be for my 1960 DeSoto Fireflite. I'm looking at putting a 2x4 carb setup on it and I don't want to hack up my stock linkage. |
|
|
|
Expert
Posts: 3780
Location: NorCal |
Why not just use some hardware store steel rod, bend it to fit and thread one end for a rod end? |
|
|
|
Veteran
Posts: 269
Location: Chesterfield, Virginia | I would get the stock linkage from Big M,& fabricate that one to fit. |
|
|
|
Veteran
Posts: 171
Location: New Richmond, WI | Big M do you have any stock linkage laying around? |
|
|
|
Expert
Posts: 1211
Location: SWITZERLAND | This is the original Single Quad Link of a 1959 Dodge, I modified it for my Dual Quad Setup (see thread). Should be available from somebody who upgraded his car.
|
|
|
|
Veteran
Posts: 150
Location: hopkinsville, kentuckky | People make linkage that is a flexible cable, and used in street rods all the time. Check with Flaming River and Lokar. good luck. |
|
|