|
|
Expert
Posts: 2196
Location: Muskego, WI | Any one have any experience with this vendor? They make sheet metal repair panels and was wondering if they were good quality parts? |
|
|
|
Expert 5K+
Posts: 8443
Location: Perth Australia | I have bought from all of them and I cant think of 1 section that just went strait on, they were all out somewhere
This has been on lower panels, rear 1/4s, doglegs, sills ect
Unless you really need the entire piece, its best to remove the minimal amount of original metal and trim the repair section down
|
|
|
|
Expert
Posts: 1207
Location: Ponder, TX | I bought some for a '56 Plymouth and spent more time reworking them than if I had made them from scratch. |
|
|
|
Member
Posts: 41
Location: South Central PA | I bought some floorpans for my 60 and they fit the area that wasn't rusted. I ended up not using them |
|
|