|
|
Member
Posts: 5
| I just installed a new turn signal cancel mechanism in my 58 savoy. The turn signals work but when I turn the wheel they cancel immediately rather than on the return. I was wondering if there was some sort of spring between the turn signal rod/steering wheel housing/ and turn signal cancel.
With a little bit of tension, it works aces, it seems like there should be something there.
If anyone can post a picture or schematic of what it's supposed to look like I'd much appreciate it.
Thanks. |
|
|
|
Expert
Posts: 2637
Location: Minor Hill, TN | I do not know what to tell you on that but mine does not cancell after the turn why I do not know. |
|
|
|
Expert 5K+
Posts: 8445
Location: Perth Australia | Most likely the tag that clicks the turn signal off is missing or broken
Look at the picture and I bet the one off your wheel is gone
(609s.JPG)
Attachments ---------------- 609s.JPG (50KB - 144 downloads)
|
|
|
|
Expert
Posts: 1730
Location: Michigan | If it is like my 55 Chrysler, you have to 'adjust' the internal arm that intercepts the tab in the above picture. Adjust as in bend slightly. Too much and it will trip in any rotation. Just enough in will only catch on the return. I had to pull the steering wheel off and on a couple of times to get it to work right. Helps if you can jack up the front end while you play with it.
Edited by Beltran 2014-09-14 12:22 PM
|
|
|