Viewing a thread - Anybody have a couple of needles

You are logged in as a guest. ( logon | register )

Anybody have a couple of needles Jump to page : 1 Now viewing page 1 [50 messages per page]	View previous thread :: View next thread
Forward Look Technical Discussions -> General Technical Discussion and Troubleshooting	Message format

koob

Posted 2016-01-30 2:55 PM (#502753)
Subject: Anybody have a couple of needles

Veteran

Posts: 120
100

Location: Bryan, TX

for a ball and trunion joint? I seemed to have lost one or two. Please reply or contact me if you can help. Thanks.

Tim Kubiak

979-229-3740

udoittwo

Posted 2016-01-31 9:46 AM (#502821 - in reply to #502753)
Subject: RE: Anybody have a couple of needles

Expert

Posts: 1348
1000

Location: Valley Forge, Pa.

Hey Tim,

Been there but I've always been told that you should never put different bearing sets together especially if they are used. Even new, manufactorers may be very slightly different.

I built a new driveshaft and did away with the trunion joint. I have a rebuilt kit that I am not going to use and am just now listing a NOS or maybe its NORS[?] rebuild kit for a 1960 Plymouth under "parts for sale" on this forum. I see them listed from $70 to 120 give or take and I am asking a lot less. You haven't said a year but I am guessing they all are the same?

Karl.

koob

Posted 2016-01-31 11:41 AM (#502841 - in reply to #502753)
Subject: Re: Anybody have a couple of needles

Veteran

Posts: 120
100

Location: Bryan, TX

PM sent.

Jump to page : 1
Now viewing page 1 [50 messages per page]

Jump to forum :

Search this forum
Printer friendly version
E-mail a link to this thread

* * * This site contains affiliate links for which we may be compensated * * *

(Delete all cookies set by this site)