|
|
Regular
Posts: 75
Location: Wilkinson, Indiana | upgraded the 61 dodge with a c-body rearend . Now I need to get the driveshaft made . Need to know what the part# of the flange piece that bolts to the ebrake drum of the transmission. Tranny is a 62.
Thanks , John |
|
|
|
Expert 5K+
Posts: 8948
Location: WHEELING,WV.>>>HOME OF WWVA | you might want to see if the old drive shaft fits unless you're just wanting rid of the trunnion setup . there's a dealer/shaft builder in texas , i think , that has the flat adaptor . ----------------------------------later
the number for the one i bought is 3120-40 .
http://www.driveshaftspecialist.com/Left-Column/Antique-Classics.ht...
Edited by 60 dart 2015-07-10 12:47 AM
|
|
|
|
Expert
Posts: 3780
Location: NorCal |
Original driveshaft should work unless the C-body rear has a different u-joint. If the u-joint is different, there is an adapter u-joint available or swap the yoke. |
|
|
|
Regular
Posts: 75
Location: Wilkinson, Indiana | Sorry, need the adapter so we can upgrade and get rid of ball and trunion. |
|
|