|
|
Elite Veteran
Posts: 1102
Location: Hayward, Calif | Hey guys, Finally got that 360 put back together. Those 9.3 pistons not leaving much area left in the combustion chamber at top dead. They put a pretty healthy valve relief in the top of those pistons. If my measurements are correct, I should have well over .100" clearance. KB recommended a minimum of .080". Got the eng installed and am hooking up all the 'stuff'. Rechecked the dr. line angle and still holding at 4 degrees. Picked up the dist. from the shop today ( had the adv. recurved ) and set it in place. I'l get started on throttle linkage tomorrow. Jerry
(360 rebuild 001.jpg)
(360 rebuild 002.jpg)
(360 rebuild 003.jpg)
(360 rebuild 004.jpg)
(360 rebuild 005.jpg)
(360 rebuild 006.jpg)
Attachments ---------------- 360 rebuild 001.jpg (87KB - 293 downloads) 360 rebuild 002.jpg (95KB - 310 downloads) 360 rebuild 003.jpg (97KB - 304 downloads) 360 rebuild 004.jpg (142KB - 310 downloads) 360 rebuild 005.jpg (152KB - 301 downloads) 360 rebuild 006.jpg (128KB - 326 downloads)
|
|
|
|
Expert 5K+
Posts: 7808
Location: Williams California | Looks like you're coming along nicely, Jerry!!
Keep up the good work!! |
|
|
|
Elite Veteran
Posts: 1102
Location: Hayward, Calif | Thanks, John ! Seems like it took a long time getting it put back together. Had a couple obstacles to overcome, but finally got them worked out. Jerry |
|
|
|
Expert 5K+
Posts: 8947
Location: WHEELING,WV.>>>HOME OF WWVA | lookin real purdy--------------------------------------later |
|
|