|
|
Veteran
Posts: 169
Location: Cochrane, Alberta | Gents; I am looking for some trim and emblems for my 58 Windsor.
1) Script "Windsors" for the front fenders
2) front grille emblem
3) emblems that go on the top of the stainless trim towards the tail light on the rear quarters
4) set of 58 chrysler wheel covers
5) pair of 58 tail lights; I have a pair of 57's to trade |
|
|
|
Expert 5K+
Posts: 9681
Location: So. Cal | I have a set of the '58 Saratoga/Windsor hubcaps that I have no further plans to use. I will email you. |
|
|
|
Expert 5K+
Posts: 9911
Location: Lower Mainland BC |
Based on the 55-58 Mopar parts pdf and specifically the diagram on page 901, and selecting 23-34-334 for the next search brings you to page 1033 and the likely part numbers for the side emblems, i.e. 1810 420 or 1810 421.
Going back to pg 901 and looking for the side emblem section 12-15-21 will lead you to page 438 where, 58 Windsor doesn't show up. Must be a Canadian Chryco thing.
Going back two pages to 899 gets you the key for the front emblem, MEDALLION 7-17-1. Chasing 7-17-1 gets you to page 208 and the 58 Chrysler grill medallion: 1754 806
Remember most parts searches do not like the space, just all 7 numbers in one shot.
A couple of 58 Saratoga photos to show the side and front emblems you seek.
Edited by 56D500boy 2017-09-01 2:16 PM
|
|
|
|
Veteran
Posts: 169
Location: Cochrane, Alberta | Excellent info; thanks as always!
I'm sure my car had those rear 1/4 emblems as the factory holes for them are there on the inside of the trunk, and the holes are smaller diameter than the side trim holes. |
|
|
|
Veteran
Posts: 169
Location: Cochrane, Alberta | Look forward to hearing from you powerflite
Edited by fireguyfire 2017-09-01 5:01 PM
|
|
|