The Forward Look Network
The Forward Look Network
Search | Statistics | User Listing Forums | Chat | eBay | Calendars | Albums | Skins | Language
You are logged in as a guest. ( logon | register )

Hemi Dipstick Install
Jump to page : 1
Now viewing page 1 [50 messages per page]
View previous thread :: View next thread
   Forward Look Technical Discussions -> Engine, Exhaust, Fuel and IgnitionMessage format
 
JGC403
Posted 2019-08-18 12:30 AM (#586163)
Subject: Hemi Dipstick Install


Member

Posts: 39
25
Location: GREENEVILLE, TN
Anyone know of a good way to get the dipstick tube into the back of the block with the engine in the car? My dad forgot to put one in before they put the engine in the car. And now that I have a new dipstick and tube I'm trying to figure out how to get it in without damaging something. The dipstick tube is in the freezer now, tomorrow we were going to warm up the engine to operating temperature and hopefully be able to somehow drive the cold tube into the block.
Top of the page Bottom of the page
NM Desoto
Posted 2019-08-19 9:11 PM (#586252 - in reply to #586163)
Subject: RE: Hemi Dipstick Install


Regular

Posts: 95
252525
I made a "special" tool from a cheap 3/8" box end wrench and a piece of 5/16" keystock. I cut off the box end about a half inch from
the box and welded on the keystock at around a twenty degree angle. I works well and probably only cost a couple of dollars.



Top of the page Bottom of the page
mikes2nd
Posted 2019-08-19 11:53 PM (#586257 - in reply to #586163)
Subject: Re: Hemi Dipstick Install


Expert

Posts: 3835
2000100050010010010025
i bought the chrome dipstick from hot hemi heads. it fit right in.
Top of the page Bottom of the page
JGC403
Posted 2019-09-03 10:56 PM (#587014 - in reply to #586163)
Subject: Re: Hemi Dipstick Install


Member

Posts: 39
25
Location: GREENEVILLE, TN
I left the dipstick tube in the freezer over night. Warmed up the engine to operating temperature, and I found a screw driver that slide inside the dipstick tube. Couple of light hits with a hammer and it was in, wasn't as bad as I thought it would be.
Top of the page Bottom of the page
Jump to page : 1
Now viewing page 1 [50 messages per page]
Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread



(Delete all cookies set by this site)