Re: IML: '82 coupe rough idle
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: IML: '82 coupe rough idle



I have a feeling the problem is in the carb adjustments. I put a new carb on my 69 & when it ran the best, it wouldn't pass the idle test. Further adjustments made some tests better & others worse. On the 3rd try, all the other tests passed by a healthy margin. The idle test barely passed.
John
----- Original Message ----- From: "Nat Hall" <nathall@xxxxxxxx>
To: <mailing-list@xxxxxxxxxxxxxxxx>
Sent: Sunday, May 28, 2006 9:53 PM
Subject: IML: '82 coupe rough idle



Hey list,

Some of you may remember I recently had my '82 fail the smog test because
of CO emissions that were too high during the treadmill test (CO at idle
was OK). Well, I decided to start simple and I replaced the O^2 sensor
since the old one was obviously toast.

That had an effect, but I'm not sure what it means.  Now the car seems to
run better overall while in motion and *seems* to have better power while
accelerating.  But now the idling has gone to crap. All I did was change
the sensor, nothing else.  The idle is rougher than it used to be,
especially when started cold-- it even stalled once on me the other day
when I was trying to warm it up. Once it's warm, the idle is still rougher
than it used to be but not so bad it stalls.  Regular driving it runs
great, like I said, maybe better than before. Absolutely no problems or
even hints of problems at all. What gives?

I know enough about engines and cars in general that I can easily get by
working on them as long as I have a FSM, but diagnosing obscure
carburetor/vaccum/emission related stuff is my weakness. Now that I have a
known-good O^2 sensor, do I just need to adjust the idle speed on the
carburetor? I didn't think I should have to do that. Anything I should look
into before that?


Also, not sure if this is related, but I found I have an exhaust leak
somewhere on the passenger side in engine compartment. My guess is the
passenger side manifold, but I can't find out exactly where it's coming
from. Could this be allowing excess oxygen in during idle and screwing up
the sensor's signal causing the roughness? If so, then why wouldn't this
affect the way the car runs while driving? How hard is this going to be to
track down and fix?


------------------- Nat Hall 1982 Imperial Coupe -------------------




----------------- http://www.imperialclub.com ----------------- This message was sent to you by the Imperial Mailing List. Please reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be shared with everyone. Private messages (and attachments) for the Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm






----------------- http://www.imperialclub.com -----------------
This message was sent to you by the Imperial Mailing List. Please reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be shared with everyone. Private messages (and attachments) for the
Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm




Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.