Re: IML: flitesweep reflectors

["mike and linda sutton" <mikanlin62@xxxxxxxxxxx>]

Someone send me a jpg or two of what this thing looks like in detail, 
especially the back side.  It almost seems that a good alternative would 
either be a resin type part that was vacuum metallized - similar to what 
Mr.G's does - or perhaps lost wax method of casting out of metal, if the 
original was pot metal that certainly doesnt have a extremely high melting 
point.

If I could see the thing it would be most helpful to determine how to make a 
replacement, since obviously Chrysler probably had them cast or stamped by 
the thousands for cheap and we dont have the tooling anymore.

Many thanks

Mikey
62 Crown Coupe 


-----------------  http://www.imperialclub.com  -----------------
This message was sent to you by the Imperial Mailing List. Please 
reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be 
shared with everyone. Private messages (and attachments) for the
Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm