Re: [Norton AntiSpam] Re: IML: '55 hesitation
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Norton AntiSpam] Re: IML: '55 hesitation



I searched the web and found out Carter is in trouble with the EPA and the parent company, ACF Industries is trying to sell the company. It doesn't look good to get one from Carter. ACF Industries Web site concentrates on railroad equipment. There is no mention of auto carbs except for the history of the company.

Roger

----- Original Message ----- From: <randalpark@xxxxxxx>
To: <mailing-list@xxxxxxxxxxxxxxxx>
Sent: Thursday, March 29, 2007 4:24 PM
Subject: Re: [Norton AntiSpam] Re: IML: '55 hesitation


I bought a new one from Carter, but that was years ago. Still might be
worth a try. Are they still in business?

Paul W.

-----Original Message-----
From: rdc2382@xxxxxxxxxxx
To: mailing-list@xxxxxxxxxxxxxxxx
Sent: Thu, 29 Mar 2007 10:19 AM
Subject: Re: [Norton AntiSpam] Re: IML: '55 hesitation

Cleaning out my old e-mails, I came upon this one that is relative to
my 55 Newport. I had to put on an inline fuel filter and remove the
glass bowl filter with the stone element. That did the trick for me. I
have tried to locate a new stone filter, but could not find one. Any
suggestions on where one gets one, and possibly how can a stone element
be cleaned?

Roger
55 Newport

----- Original Message -----
From: randalpark@xxxxxxx
To: mailing-list@xxxxxxxxxxxxxxxx
Sent: Saturday, June 17, 2006 11:43 AM
Subject: [Norton AntiSpam] Re: IML: '55 hesitation


While all of this is absolutely true, if this were happening to my '55
Imperial, I would clean/replace the "stone fuel filter", remove the
extra in line filter (as it could be actually restricting fuel flow),
and replace the fuel pump and flex-line. This is all assuming that the
car had been driven successfully before this happened and since any
recent work had been done. If not, then I would also inspect & gap the
duel ignition points.

All of these things should be done anyway. The problems with today's
fuels that Dick has described have caused fuel pump diaphragms on my
cars to prematurely go bad, with similar symptoms. The flex line is a
likely culprit. I mention the ignition points since a problem there can
lead to similar symptoms, and also, because while in the shop, the
mechanic may leave the ignition on (without the engine running) for an
extended period, while taking a phone call of a coffee break. This can
lead to burned contacts, and a very damaged point set. This happened to
me while my car was in the shop for a routine service. My car ran, but
not quite correctly. It took months to figure out, but the solution was
simple.

At least you have plenty of food for thought.

Paul W.

-----Original Message-----
From: Dick Benjamin <dickb@xxxxxxxxx>
To: mailing-list@xxxxxxxxxxxxxxxx
Sent: Sat, 17 Jun 2006 07:31:25 -0700
Subject: RE: IML: '55 hesitation

This definitely sounds like fuel starvation to me. Given the
occurrence in hot weather, I suspect you may be having some vapor lock
problems. Modern gasolines are much more likely to develop vapor
lock. Another thing that will cause vapor lock, besides the obvious
overheated fuel line, is a pinhole leak in the fuel line from the tank
to the pump. These leaks are very hard to find because they don’t leak
fluid enough to spot or smell, but they do ingest air when the fuel
pump is working, producing a vacuum in that line. Any air in the lines
at all will lead to vapor lock much more readily than liquid fuel.

I’d approach the problem in steps:

* Test your fuel pump output. It should deliver a coffee can full of
gas at idle within about 15 seconds, and if you block the output line,
it should produce at least 3.5 PSI. This can be done with a hose, a
coffee can, and a vacuum gauge (which will also read pressure). Just
start the engine and let it idle with the hose on the pump outlet – the
engine will idle happily for long enough using the fuel in the float
bowl.
* If that result is normal, then pressurize your fuel line from the
pump back to the tank – don’t exceed a few PSI as the tank can’t take
it, but just a small amount of pressure should show up any weak spots
on the fuel line. While you’re at it, replace all the fuel hose with
SAE30R9 hose – the older stuff isn’t able to stand the new oxygenates –
in fact I’d do that anyway, just to make sure. Just buying new hose at
the auto parts place may not get you the right stuff – check the
marking on the hose. Most stores still stock 30R7, although that is
obsolete for modern fuels.
* While you are inspecting the fuel line, make note of any place where
the fuel line is passing near anything hot – especially the exhaust
system, and in the engine compartment, anything near the engine block.
If you can, re-rout the lines to where they will be cooled by the air
stream, as far away from a source of heat as you can get them.
* Some cars seems to have great difficulty with this problem, and it is
getting worse as the EPA fiddles with the gas formula – you may have to
break down and install an electric booster pump – do it back at the
tank area, as low as you can mount it so that the pump will gravity
feed from the tank, and stay cool, but keep it safe from road debris.
Outside the frame rail, just in front of the rear wheel is usually a
good place. You can wire it so that it will only run when you flip a
hidden switch, but be sure to wire it through the ignition switch also,
so it will go off when you turn off the engine. This will also be a
big help to your beleaguered starter, having to crank that Hemi on 6
volts!

This problem doesn’t show up on modern cars, because since sometime in
the late 70s, all cars have a vapor return line to the tank from the
fuel pump, and since the advent of EFI, cars have circulating fuel in
great abundance running through the lines all the time – the tank pump
supplies about 5 times the needed quantity of gas, and a return line
keeps the excess gas circulating back to the tank, so the fuel in the
supply line is always as cool as the fuel in the tank. Next time buy
an 81 with EFI – your problems will be gone! ((or at least
different?!))

Dick Benjamin

--------

From: mailing-list-owner@xxxxxxxxxxxxxxxx
[mailto:mailing-list-owner@xxxxxxxxxxxxxxxx] On Behalf Of Jim Poltrock
Sent: Friday, June 16, 2006 11:31 AM
To: mailing-list@xxxxxxxxxxxxxxxx
Subject: IML: '55 hesitation


Hi all-

My ’55 sedan just started hesitating while at cruising speed. It is
acting as though it is momentarily starved for gas, then it runs fine,
then starved again. If I take my foot off the accelerator pedal and
get back on it runs fine again for a bit before it hesitates again.

Since I got her back on the road last fall she has run like a top. It
still starts and idles fine- no problems there. And the only time it
hesitates is when she is warm and running down the road. I installed a
new fuel filter and put a can of Seafoam in the tank (always filled
w/93 octane). It has been warm here lately and I wonder if that has
anything to do with it. The carb was rebuilt last year and, like I
said, she has run fine up until now. I still have the stone filter
inline (for looks as the Wix pre-filters for it). The clear bowl is
only about 20% full while idling and the stone looks clean.

Any suggestions or input? I have really been enjoying driving the old
girl lately (gas prices be damned) and look forward to solving this
riddle ASAP. Thanks in advance for any help/direction on this.

Jim Poltrock
Salem, WI.
’55 sedan
Wisteria blue/rhapsody in blue
41k miles




--------
Check out AOL.com today. Breaking news, video search, pictures, email
and IM. All on demand. Always Free.


________________________________________________________________________
AOL now offers free email to everyone.  Find out more about what's free
from AOL at AOL.com.
=0


-----------------  http://www.imperialclub.com  -----------------
This message was sent to you by the Imperial Mailing List. Please
reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be
shared with everyone. Private messages (and attachments) for the
Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm



-----------------  http://www.imperialclub.com  -----------------
This message was sent to you by the Imperial Mailing List. Please reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be shared with everyone. Private messages (and attachments) for the
Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm



Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.