Re: IML: Rust prevent in box frame

[<mopar413@xxxxxxxxxxx>]

How bad did it rust the new one.  If it is surface rust no problem.  Just clean and paint or use something like por 16 or an eastwood product.  Other wise build a new and clean and paint  like above.
---- charles major <charlesdmajor@xxxxxxxxx> wrote: 
> question:
> I am replacing a section of frame rail. I built a box
> frame to weld in, but I left it in the truck and it
> got rained on (sad face), and it now has much water
> inside my NEW frame!
> Ok can I save it or just start over?
> And when I do build a new one how do i keep it from
> rusting from the inside?
> I had a thought to drill a few holes and fill it with
> WD-40 after it is all welded, and then maybe displace
> with a foam. I know that foam-a-fill is not a good
> idea because it is open cell foam and will hold
> moisture (am I correct). Is there a closed cell foam
> for this?
> 
> 
> Charles Major
> 270.791.4139 Moble
> 208.728.4443 FAX
> 
> 
>       ____________________________________________________________________________________
> Be a better friend, newshound, and 
> know-it-all with Yahoo! Mobile.  Try it now.  http://mobile.yahoo.com/;_ylt=Ahu06i62sR8HDtDypao8Wcj9tAcJ 
> 
> 
> -----------------  http://www.imperialclub.com  -----------------
> This message was sent to you by the Imperial Mailing List. Please 
> reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be 
> shared with everyone. Private messages (and attachments) for the
> Administrators should be sent to iml.webmonster@xxxxxxxxx
> To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm
> 


-----------------  http://www.imperialclub.com  -----------------
This message was sent to you by the Imperial Mailing List. Please 
reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be 
shared with everyone. Private messages (and attachments) for the
Administrators should be sent to iml.webmonster@xxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm