Re: IML: LED lights
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: IML: LED lights



Who is the vendor mentioned in your last paragraph, and what is the part number?

Gary Kitterman
'56 C-73 "Babe"


-----Original Message-----
From: Marcos del Castillo <the_dusster@xxxxxxxxxxx>
To: mailing-list@xxxxxxxxxxxxxxxx
Sent: Wed, 20 Feb 2008 6:40 am
Subject: RE: IML: LED lights

I think I'd only previously purchased bulbs from Superbrightleds.com.  My lebaron uses 2 dual-filament bulbs (stacked vertically) in each brake/tail/turn lamp, 2 tail lamps in the trunk lid, and 2 in the CHMSL.  All my experimenting took place over about the past 4 years.  The things I was looking for with this mod were adequate fill of the reflector, a noticeable difference between the dim and the bright setting, and clear visibility of the brake lights when viewed in sunlight.
 
I originally puchased enough LED bulbs to replace all of these.  These were the original design, with only axially-mounted LEDs.  I was not pleased at all.  None of my main requirements were met.  You got basically "points" of light that looked like a firefly stuck in the taillamp.  So I switched back. 
 
Later, I was researching other vendors, and I came accross one that may have been the one mentioned earlier by another IML member.  These looked more promising, as they incorporated some radially-mounted LEDs to provide some fill.  Unfortunately, they were $60 apeice, so it would have cost $240 just to do the 4 main lamps, and even $60 to try one out was too much.
 
Then later, Superbright LEDs put out a wedge-based bulb that incorporated a single high-flux (luxeon?) emitter, that even though it was axially mounted, promised illumination in 180*.  I decided to purchase one and try it out.  It was brighter, and provided somewhat better fill, but still not good enough in my opinion, still had the firefly impression.  I felt that it would have been better designed with a shorter base, to move the emitter further back into the reflector.  Also, there were issues with the dual-brightness feature not working correctly.
 
Even later, they introduced a design that was similar to the originals I purchased, but included 6 radially-mounted LEDs for fill.  I purchased a pair of these to test them out.  Again, better fill than the originals, but still not good enough, still too dim in bright sunlight, and not enough difference between bright and dim.  At least the flasher worked properly.
 
Lastly, the discussion was started on Allpar, so I chimed in and someone mentioned the vendor I posted earlier.  The vendor offers many different designs for the same bulb type, so I emailed him about which ones would be best for my application and my reqirements.  He recommended one type, but was also up front about cautioning me that they may not illuminate as well as standard bulbs.  I ordered a pair to test them out, and found that they were more than satisfactory in meeting all 3 of my requirements, and performed as well as incandescents, while providing the nice deep red color, and more distinct flash of LEDs.  So I purchased 2 more of the dual-brightness bulbs, and 2 bulbs for my CHMSL.  I've decided to leave the trunk lamps as they are for now.  I've had these bulbs for over 6 months and am very happy with them.
 
 
 
 
> Date: Tue, 19 Feb 2008 20:35:35 -0800
> From: dansgarage@xxxxxxxxxxxx
> To: mailing-list@xxxxxxxxxxxxxxxx
> Subject: RE: IML: LED lights
> CC: the_dusster@xxxxxxxxxxx
>
> Hi MArcos!...I also have been checking into the use of LED's as replacments on my Imperial ('66 LeBaron) anda I an VERY curious as to WHICH suppliers/websites you have tried andthe reason's WHY you said you were not particularly "satisfied" with the designs you have so far tried. This could save me (and other IML'rs) lots of time/aggrivation in looking for that "perfect" LED replacement!
> thanks for any info you can share!!!
> Dan Melnik
>
>
> ---- Marcos del Castillo <the_dusster@xxxxxxxxxxx> wrote:
>
> =============
>
> I've tried out many different designs of drop-in replacement LED bulbs for the rear of my '89 Lebaron coupe and was not satisfied with any of them, including any of the ones sold by superbrightleds.com, until I saw this thread over at Allpar:
>
> http://www.allpar.com/forums/index.php?showtopic=95312&st=0
>
> where this vendor was mentioned: http://frickinbrite.com/catalog/index.php
>
> I tried some from them and was very pleased. You can see photos of the results on the second page of the Allpar thread. Very bright, and with excellent fill. The color in person is a very nice, intense red. If you switch to LEDs in any lights that flash, you will want to replace your thermal flasher with an electronic one.
>
>
> ----------------- http://www.imperialclub.com -----------------
> This message was sent to you by the Imperial Mailing List. Please
> reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be
> shared with everyone. Private messages (and attachments) for the
> Administrators should be sent to iml.webmonster@xxxxxxxxx
> To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm
>



Helping your favorite cause is as easy as instant messaging. You IM, we give. Learn more. =

More new features than ever. Check out the new AOL Mail!


Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.