Re: IML: my 1961 Imperial wirering burned up
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: IML: my 1961 Imperial wirering burned up



Keep looking, and follow those wires from the amp meter. It is possible that the problem is restricted to them. The ammeters have been know to short out. Overheating wires can also be caused by a loose or corroded connection. The heat can be enough to cause the insulation to melt. Once the ammeter has become open, the car won't run.

I hope your wiring is otherwise okay. It will be a great time and money saver if that is all that was damaged. The ammeter will jump around due to high resistance in the circuit, a bad voltage regulator, or a short going through a circuit breaker.

Paul W.


-----Original Message-----
From: Mark Battesby <a1web@xxxxxxxxxxxxx>
To: mailing-list@xxxxxxxxxxxxxxxx
Sent: Tue, 26 Feb 2008 8:07 am
Subject: Re: IML: my 1961 Imperial wirering burned up


I checked under the hood really good and could not find any burnt wires at all. I noticed before all this happened my amp meter was jumping all over the place. The two wires coming off the amp meter seem to be burnt the worse. I have the dash taken apart. I'm splitting open all the taped wires looking for any burnt ones. It seems to have started inside the car. Another question. For five years now I have been trying to figure out where the light source plugs into the push button heater controls. That's the only area that doesn't light up. For the life of me I just don't see how a light source attaches to those clear push buttons

PAUL WENTINK <randalpark@xxxxxxx> wrote:
I think you experienced a short circuit. Check under the hood. I
believe that you will find more burned wires. The voltage regular
wouldn't have likely been the cause. There are several other areas to
look, both under the dash and under the hood. The wiring diagrams are
very good. When you have time, you can trace through them and determine
what went bad, then replace the wiring. The instrument cluster is easy
to remove. You may find something there, but I suspect there will be
lots of burned wires to and from the source of the trouble. If you have
done any recent work, that might be a good place to start. I hope this
helps. Nearly all the accessories are fuse protected. I would guess it
is within the main power circuit.

Paul W.


-----Original Message-----
From: Mark Battesby
To: mailing-list@xxxxxxxxxxxxxxxx
Sent: Tue, 26 Feb 2008 3:38 am
Subject: IML: my 1961 Imperial wirering burned up


The other day while driving my car at night suddenly I lost all power
and my car filled with smoke. I noticed that both wires going to my amp
meter and one wire to my ignition. burned up . what could have cause
this to happen ?? any place I should look first I was thinking maybe it
was the voltage regulator any clues thanks

________________________________________________________________________
More new features than ever. Check out the new AOL Mail ! -
http://webmail.aol.com

----------------- http://www.imperialclub.com -----------------
This message was sent to you by the Imperial Mailing List. Please
reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be
shared with everyone. Private messages (and attachments) for the
Administrators should be sent to iml.webmonster@xxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm





-----------------  http://www.imperialclub.com  -----------------
This message was sent to you by the Imperial Mailing List. Please reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be shared with everyone. Private messages (and attachments) for the
Administrators should be sent to iml.webmonster@xxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm



Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.