Re: [FWDLK] EXHAUST MANIFOLD FINISHING
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [FWDLK] EXHAUST MANIFOLD FINISHING



I never had luck with the eastwood stuff lasting more than a couple years before it started rusting.

Nick




--- Begin Message ---
  • From: eddee <eddee@xxxxxxxxxxxxx>
  • Date: Wed, 28 Apr 2004 19:26:35 +0000
Hello List members
 
I have decided to try and prep and paint my own exhaust manifolds.
 
Has anyone personally done this using either 'EASTWOOD' or 'POR-15' exhaust manifold paint???
 
A one pint can is about the same price,,but I was wondering if anyone has experiences of good luck or bad with either??
 
---The EASTWOOD gray is advertised good up to 1200 degrees and requires no special 'cure' requirements.
---The POR-15 gray is advertised for up to 1400 degrees but cure time (at idyll for 10 min) is needed between coats.
(this is not a problem,since I'll stick them in the oven for 10 minutes while the wife is not looking) 
----Both need sand blasted clean manifolds.
 
Does the POR-15 have better rust prevention properties?
Has anyone used the 'new' aerosol cans?
 
Any experiences would be welcome
 
ED ECKERSON
LI  NY
57  FURY

--- End Message ---



Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.