Re: [FWDLK] Shift cable release-

[David Homstad <dhomstad@xxxxxxxxxxx>]

One more recommendation: the manual suggests that you only release the clip
sufficiently to release the cable end. If you move the clip too much, it can
fall off, requiring removal of the pan to reinstall it.

Dave Homstad
56 Dodge D500

-----Original Message-----
From: Forward Look Mopar Discussion List
[mailto:L-FORWARDLOOK@xxxxxxxxxxxxx]On Behalf Of Mike Apfelbeck
Sent: Monday, February 21, 2005 3:00 PM
To: L-FORWARDLOOK@xxxxxxxxxxxxx
Subject: Re: [FWDLK] Shift cable release-

First remove the bolt holding the outer cable to the trans case, remove the
neutral starter switch, then reach into the hole with a slender screwdriver
and release the clip that holds the inner cable end in place on the shift
lever. If you have the trans in reverse, the cable end will be farthest to
the rear. Shine a strong flashlight into the hole and you will see how to
release the clip.

Mike

At 08:00 AM 2/21/2005, Bob Moore <mustang@xxxxxxxx> wrote:
>Hi,
>
>Could anyone please give me a refresher course on releasing the shift
>cable from the torqueflite?
>
>I know you push a pin in through the hole, but what gear should it be in,
>and is the diameter of th pin critical (i.e. should
>a 1/4-20 bolt work?)
>
>TIA,
>
>-Bob

*************************************************************

To unsubscribe or set your subscription options, please go to
http://lists.psu.edu/cgi-bin/wa?SUBED1=l-forwardlook&A=1

*************************************************************

To unsubscribe or set your subscription options, please go to
http://lists.psu.edu/cgi-bin/wa?SUBED1=l-forwardlook&A=1