Re: [FWDLK] Oil pump priming
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [FWDLK] Oil pump priming



The distributor turns counterclockwise on the B & RB motors, clockwise on the A motors, at tdc the holes in the cam journal should line up with the oilways to the heads.

Mike

At 01:29 PM 2/27/2010, Gary Nelson wrote:
Anthony

Run your drill CW. I would not be concerned with priming pump or filter. You
are not turning the motor over, only forcing oil to filter, oil galleries
and to all bearing surfaces. The rockers are the biggest challenge. Rockers
are oiled each 360 degrees of the cam rotation. Continuous oiling, like
crank and rod bearings would over oil the top end of motor. Therefore, you
will need to rotate crank a few degrees at a time (while you are priming),
until you see oil flowing around the rockers.
I primed a 392 one time. Although Dick Landy's shop assemble the short
block, I wanted to see oil at the rockers. I primed and rotated crank a
little at a time and never saw oil. I finally had to pull the cam out to see
the oiling holes. I indexed the cam with the oil holes facing up to each
head.
I saw lots of oil then.
Maybe some one knows the degrees from TDC the cam oils the rockers. Maybe it
is at TDC. I did not have the damper on my motor when priming.

Thank you,
Gary, the parts doc
Reno, Nevada 89521 USA
The Biggest Little City In The World
Mail: garythepartsdoc@xxxxxxxxxxxx
775 851-1420








-----Original Message-----
From: Forward Look Mopar Discussion List
[mailto:L-FORWARDLOOK@xxxxxxxxxxxxx]On Behalf Of ajl
Sent: Saturday, February 27, 2010 6:07 AM
To: L-FORWARDLOOK@xxxxxxxxxxxxx
Subject: [FWDLK] Oil pump priming


One more question;

Is it a practice to fill the oil filter up with as much oil as possible,
also to fill the oil pump with petroleum jelly?

Or is their a way to fill the pump up with oil prior to using the shaft
setup for priming?

Anthony

*************************************************************

To unsubscribe or set your subscription options, please go to
http://lists.psu.edu/cgi-bin/wa?SUBED1=l-forwardlook&A=1
No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 9.0.733 / Virus Database: 271.1.1/2707 - Release Date: 02/26/10
11:39:00

*************************************************************

To unsubscribe or set your subscription options, please go to
http://lists.psu.edu/cgi-bin/wa?SUBED1=l-forwardlook&A=1

*************************************************************

To unsubscribe or set your subscription options, please go to
http://lists.psu.edu/cgi-bin/wa?SUBED1=l-forwardlook&A=1



Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.