Re: [FWDLK] Removing Undercoating
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [FWDLK] Removing Undercoating



Ron, 

I used a heat gun & wide putty knife.  Use 1/2" , 3/4" conduit sharpened on the end for the small round corners.  Cleaned up with PPG 440 grease & wax remover.

Mike Singer




At 11:20 AM 11/18/2010, you wrote:
Ron:
 
    The only thing that comes to mind for removing undercoating is mineral spirits.  It is reasonably safe, but will require a lot of work.
 
    John
 
In a message dated 11/17/2010 11:12:27 P.M. Eastern Standard Time, ronbo97@xxxxxxxxxxx writes:
Hey Gang -

My 59 Dodge's inner fenders have factory undercoating that I'd like to
remove. Using a torch is definitely out. Sandblasting may remove some, but
I'd like to chemically remove all of it. Does anyone have a method that will
disolve or at least soften the undercoating to the point that it'll come off
easily with a putty knife ?

Thanks,

Ron

*************************************************************

To unsubscribe or set your subscription options, please go to
http://lists.psu.edu/cgi-bin/wa?SUBED1=l-forwardlook&A=1

*************************************************************

To unsubscribe or set your subscription options, please go to
http://lists.psu.edu/cgi-bin/wa?SUBED1=l-forwardlook A=1

Mike Singer
Phone:  814-486-1881 Work
         814-486-1010 Home
Fax:    814-486-2080
e-mail: desoto@xxxxxxxxxxxxxx
11769 Route 120
Emporium, PA

*************************************************************

To unsubscribe or set your subscription options, please go to
http://lists.psu.edu/cgi-bin/wa?SUBED1=l-forwardlook&A=1




Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.