Re: [FWDLK] Flathead six side covers (valves)

[William Huff <whuff@xxxxxxxxxx>]

You might try joining this group and then seeing if someone is close by
you.  They can probably cast the extended covers using the two you
have to make a pattern.

http://groups.yahoo.com/group/hobbicast



Bill Huff

At 8/31/201110:25 AM, George McCollam wrote:

Resend below message:

Subject: Flathead six side covers (valves)

Hello All,

 Might anyone know where to get or any contacts. leads for the side  covers for the six flathead? I have a set of cast aluminum side covers made years ago by Phillips Performance out of Washington State I need to find another on to use to lengthen the two I have so as to be able to fit to the longer Chrysler 256 motor. So I need at least one of the original cast aluminum covers to use for extending the two I have. Anyone  help???

Thanks George

*************************************************************

To unsubscribe or set your subscription options, please go to
http://lists.psu.edu/cgi-bin/wa?SUBED1=l-forwardlook A=1

*************************************************************

To unsubscribe or set your subscription options, please go to
http://lists.psu.edu/cgi-bin/wa?SUBED1=l-forwardlook&A=1