Re: [Chrysler300] Question about intake manifold gasket 300H
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Chrysler300] Question about intake manifold gasket 300H

On 12/24/15 18:13, Michael Moore mmoore8425@xxxxxxx [Chrysler300] wrote:
> Thanks Rich, I will certainly plan on doing that with increasing levels
> of torque in at least two stages.
> Thanks, and Merry Christmas to you!
> Mike Moore
> 300H
> On Dec 24, 2015, at 2:14 PM, Rich Barber <c300@xxxxxxx
> <mailto:c300@xxxxxxx>> wrote:
> You might want to start at the center and work outward to prevent
> formation of a “bridge” in the middle.  There may even be a torqueing
> sequence diagram in manual.
> Speaking of Immanuel, Merry Christmas to all,
> Rich Barber
> Brentwood, CA

There is a proper bolt torquing sequence.

Think of a large spiral winding, working from the center you follow the
spiral as you torque, 2 stage torquing can't hurt.

Paul Holmgren
The supreme irony of life is that hardly anyone gets out of it alive.
Robert A. Heinlein

Posted by: paul <paulholm@xxxxxxxxxxxxx>

To send a message to this group, send an email to:

To unsubscribe from this group, send an email to bob@xxxxxxxxxxxxx or
go to

For list server instructions, go to

For archives go to

Yahoo Groups Links

<*> To visit your group on the web, go to:

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    (Yahoo! ID required)

<*> To change settings via email:

<*> To unsubscribe from this group, send an email to:

<*> Your use of Yahoo Groups is subject to:

Home Back to the Home of the Forward Look Network Archive Sitemap