Re: [Chrysler300] Thompson Power Steering
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Chrysler300] Thompson Power Steering

The Thompson pump was last used in 1957. Later pumps were different, and the 1962 was a Federal design I believe.

Steve Albu

On Thu, Jun 2, 2016 at 12:14 PM, Charlie V cv300g@xxxxxxxxx [Chrysler300] <Chrysler300-noreply@xxxxxxxxxxxxxxx> wrote:

Is the 57 pump same as the  62 pump ? I got mine for my 62 locally, about 3 miles away

 If same I can get one today or tomorrow  and send it to you. It was very reasonable. 



Hi George,

It's been a few years, but I'm pretty sure I was able to pick up every Oring I needed for my Thompson rebuild at a local hydraulic/pneumatic supply house. And very inexpensively too.


On Thu, Jun 2, 2016 at 2:34 PM, George McKovich george@xxxxxxxxxxxx [Chrysler300] <Chrysler300-noreply@xxxxxxxxxxxxxxx> wrote:

Does anyone have a NAPA part number for the large O ring/seal for the 57 Chrysler Thompson Power Steering pump??



Posted by: Steve Albu <saforwardlook@xxxxxxxxx>

To send a message to this group, send an email to:

To unsubscribe from this group, send an email to bob@xxxxxxxxxxxxx or
go to

For list server instructions, go to

For archives go to

Visit Your Group
Yahoo! Groups
PrivacyUnsubscribeTerms of Use


Home Back to the Home of the Forward Look Network Archive Sitemap