Re: [Chrysler300] 300F A/C Compressor Gaskets
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Chrysler300] 300F A/C Compressor Gaskets

Hi Mark,
I rebuilt an early compressor. The only gaskets I could source was the oil reservoir (pan) gasket. I cut new gaskets for the heads. Very tedious as there is a narrow separation between the chambers on each head. Then there is the valve plate between head and case making it even more difficult as you will have to cut 2 gaskets for each. On my next rebuild I will only flush acetone through the cylinders a few times until runs clear. If the compressor turns free and indicates it is pumping I would not disassemble. You can remove pan and check rods and crank journals and wash out the case with out to much labor. You also have to consider the crank seal. You may find at Classic Air I listed below. Years ago I made up a batch of seal conversion to late seal that is easy to find. I no longer have kits. You can make a conversion with out to much pain, I think. I would have revisit what I did. Could make a good web site tutorial that would show step by step conversion.
910 Freeport Parkway, Suite 100
Coppell, Texas 75019
Phone – 817-442-4822
5133 W. Idlewild Ave.
Tampa, FL 33634
Phone – 813-251-2356
Take Care,
AKA Gary the parts doc
Sent: Tuesday, April 18, 2017 1:14 PM
Subject: Re: [Chrysler300] 300F A/C Compressor Gaskets

Hi all - does anyone have a source for a gasket kit for the pre-1961 a/c compressors? I checked with Jeff Carter, he doesn't have them. I did get a brush kit from Jeff, so while the clutch is off and unit is out of the car, it would make sense to update the gaskets as well. Thanks.
Mark Hopkins


Posted by: "Gary Nelson" <gnelson@xxxxxxxxxxxx>

To send a message to this group, send an email to:

To unsubscribe from this group, send an email to bob@xxxxxxxxxxxxx or
go to

For list server instructions, go to

For archives go to


Home Back to the Home of the Forward Look Network Archive Sitemap