{Chrysler 300} splice point 300K window power feed

["'James Douglas' via Chrysler 300 Club International" <chrysler-300-club-international@xxxxxxxxxxxxxxxx>]

Anyone know off hand the location of the W-2, W-3, W-4 splice point on the window lifts?

 

My driver’s side rear switch will not work at the window. The master at the driver’s door works fine. I checked the switch, and it is fine. The center feed to the switch is dead.

 

That wire on the schematic looks like a factory furnace splice someplace. It is after the circuit breaker. Before I go hunting for it, I am hoping someone can tell me where it is to save me some time. It is also possible that all three of the wires are ring terminals onto the circuit breaker, but I have not gone hunting yet.

 

All the other switches are fine. I am assuming a wire problem someplace.

 

Thanks, James

--
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
---
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion on the web visit https://groups.google.com/d/msgid/chrysler-300-club-international/CY5PR19MB61710F5FDB0D35D4ADBDC9CB932EA%40CY5PR19MB6171.namprd19.prod.outlook.com.