{Chrysler 300} ball joint tapper degrees ?
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

{Chrysler 300} ball joint tapper degrees ?



Does anyone know definitively if the 1964 Chrysler ball join tapper is 7 Degrees or 10 Degrees or something else?
 
I am going to have to grind or mill out the stuck ball joint studs from the spindle. If I can get one end out, I can then use a ½ steel bar through the hole and the opposite end properly supported can be pressed out.  I have managed to get a ½ hole in the lower, not quite centered. I am using a Dremel to try and get two sides down to the tapper and then perhaps it will some out. In any case, I suspect the tapper may get a little messed up, so I need to order reamers TODAY to get them moving.
 
Thanks for any assistance.
 
In the event someone has a spare spindle that is bear and they want to sell it, let me know. I found one NOS and it is on the way. But I still have to get one more either apart clean or fine a another one.
 
James
 

--
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
---
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion on the web visit https://groups.google.com/d/msgid/chrysler-300-club-international/CY5PR19MB6171CC6E898C2ACFBCB1CE0593342%40CY5PR19MB6171.namprd19.prod.outlook.com.


Home Back to the Home of the Forward Look Network Archive Sitemap


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.