RE: oil pan fitment

[victim1234 <victim1234@xxxxxxxxxx>]

${top_text_ad}
What about a BFH?????

-----Original Message-----
From: Mr Christopher [mailto:MrChristopher1@xxxxxxxxxxx] 
Sent: Tuesday, July 07, 2009 3:33 PM
To: 1962to1965mopars@xxxxxxxxxx
Subject: Re: oil pan fitment


Ball peen hammer...

Christopher Glick


----- Original Message -----
From: Brian Safford <hzf9vv@xxxxxxxxx>
To: 1962to1965mopars@xxxxxxxxxx
Sent: Tue, 7 Jul 2009 19:29:03 +0000 (UTC)
Subject: oil pan fitment

I'm getting some leakage around the rubber seals in the front and rear
of my oil pan.

All the pan holes have been pushed in by the pan bolts; I'm wondering
if a simple fix is to flatten those out?

I don't have a vice (sp?) or anything resembling one, so am a bit
unsure how to go about flattening those out, so some MacGyver-like
suggestions are welcome :-)

Thanks in advance,
Brian Safford
'62 Dart 440 4-door / Poly 318


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 

${bottom_text_ad}
----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.

This email was sent to: ${recipient}

u/?bUrDWg.${encoded_sub_id}.${EMC}