Re: 273 Rebuild status
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: 273 Rebuild status



Steve,

Good Point. The New pistons will require that, even with all the manual checks Egge does, there's still the need when adding pistons and pins that something might be askew. Dont want to flub up the forged crank.

Will have to add it to the list.  Appreciate it.

--Tom

Steven Charette wrote:
Tom,
	You got money tucked away to rebalance the rotating assembly?

SC
-----Original Message-----
From: Tom Watters [mailto:tomwatters@xxxxxxxxxxx] Sent: Thursday, January 21, 2010 10:14 PM
To: 1962to1965mopars@xxxxxxxxxx
Subject: 273 Rebuild status

Well, it looks like I'll be rebuilding the 273 rather than just a refresh
(Rings & beargings).  Needs boring, which means pistons and the like.

After bumping around on the phone, I got some good recommendations of friend
of the the local car club president for a machine shop.  It seems to be on
the high end of average, but I can tell he does know his stuff.  When I
talked to Nellis Machine or Las Vegas Crank and Machine, they didnt leave me
with a comfortable feeling about taking in my original block to them.  I
told HBR Competition Engies I will be dropping off the Block, Heads, Crank
and Pistons tomorrow afternoon. Total for Bore (175-200)/Crank Turn (95)/Cam Bearing install
(75)/re-condition rods (25-35) is at a 500-600, depending.

This will cause me to buy pistons. Only one company makes (egge) the
10.5:1s, Those will run about $300

Cam/Lifters from Racer Brown is now on Order $235+Tax.  Ordered # ST-1 -
Mechanical Cam.  Its a little lumpier than the stock HiPo Cam (450 lift
instead of 425), but not as big as the D-Dart race cam (495 lift).  It
should give me what I want.

So barring a ton of head work, the rest of the parts I'm looking at will be
about $300 (Timing Chain, Teardown set, Freeze Plugs, Bearings, Rings, etc)

Total for a full rebuild minus head work, I'm looking at $1435.  if I need
head work, Usually about another $200-$500

If He were assembling, it'd be another 1000 or so.

Now to get the taxes submitted so I have the funds to pay for it with my
return.  ;-)

Regards and Happy Moparing.
--Tom


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.





Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.