Scored Cylinders ?! bad or ok ?

[Eric R <hoodoovoodooray@xxxxxxxxx>]

Soooo...  I have my 361 up on my Harbor Freight engine stand waiting
for it to colapse on me while I'm doing the rear main seal.   I get
curious and peek into the cylinders from below.  I notice a few of
them have one decent sized vertical score that you can definately feel
with your finger or nail.  Some are about an inch long and half inch
across.

I only drove the car home about 50 miles when I bought it.  I seem to
run fine and sounded ok. Then took engine out for upgrades.

The  vertical scores are below what looks to be the really smooth area
that the rings create on the cylinder walls.  The walls are nice and
shiney and none of the scores go up that high, they stop right at the
bottom of the shiney walls.

Engine had oil pressure on the after  market gauge ..  about 40psi.

So,  is this ok?    What is this from.    ....  perhaps a blocked oil
pickup tube ?   my next post.

-- 
--
Please address private mail -- mail of interest to only one person -- directly to that person. That is, send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.