Re: Mopar Tapoered Axle Brake Coversion Link

[carverex@xxxxxxx]

In response to Steve Mick's question, here is what Richard Ehrenberg had to say about "green" (ball) bearings in a tech Q&A.

http://www.moparaction.com/tech/quest1/HOW_GREEN_ARE_MY_BEARINGS.html

Regards

Lyle

On Thursday, August 28, 2014 2:59:29 PM UTC-4, Dennis C. wrote:

There has been a couple of discussions about tapered axles, replacement of complete differentials and such.  This may have been covered but here is a very good article describing how to convert from a tapered hub / brake drum unit to a standard brake drum.  Much easier to service and less expensive.

This is also a good time to change over to standard studs if you are still running the left handed studs on the left side.

http://hotrodsandhemis.com/PolaraRearBrakes/TaperedAxleBrakes.html

Dennis C.

-- 
-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

--- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx.
For more options, visit https://groups.google.com/d/optout.