Re: Drag Strip Failure Help Needed
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Drag Strip Failure Help Needed



Checking the power - another good idea. Thanks.
 
Akron Don Gallimore



From: mcreglow <mcreglow@xxxxxxxxx>
To: 1962to1965mopars@xxxxxxxxxxxxxxxx
Sent: Sunday, July 10, 2016 8:24 AM
Subject: Re: Drag Strip Failure Help Needed

don,

from what you are describing, it sounds like it is pump related.  before replacing, what is the amperage going to the pump?  low amperage will cause less torque which could explain the surging phenomenon.  make sure it is fused per instructions.  
check on your voltage at the pump.  low voltage will reduce the RPM of the pump motor.  
also, validate grounding.  

hope that helps,
mike     



--
--
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.

---
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx.
For more options, visit https://groups.google.com/d/optout.


Home Back to the Home of the Forward Look Network