IML: 58 Upper/Lower Control arm
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

IML: 58 Upper/Lower Control arm



Hi Folks
 
I am rebuilding the front suspension/steering of my 58 and also doing a AAJ disc brake conversion.  I am in the process of bolting upper and lower control arms back on.  In the Factory service Manual It says "with control arm  in normal position tighten nuts to required torque settings"  My questions are
 
Where is normal position?
Is this critical and what happens if not in correct position can damage occur.
 
Any advice would be appreciated and would probably not be the last question until I have successfuly put the entire front end back together.
 
Regards
Chris  
 


Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.