Re: IML: Harmonic Balancer
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: IML: Harmonic Balancer



I have only had one of these actually fail on a 413, and it made a lot of noise since it was rubbing against the timing chain cover part of the time. I doubt that it is causing this problem. You may want to check your timing chain by removing the distributor cap and watching the rotor as you move the engine by hand. See if there is a long delay between the movement of the crank shaft and the rotor. If not, you're in good shape. The timing gears were metal in the 1960 model, and not as prone to failure as those used in the 440. Old worn timing chains do stretch, so it should be checked.

Paul W.

-----Original Message-----
From: Rob van der Es <r.vdes@xxxxxxxxxxxxxxx>
To: mailing-list@xxxxxxxxxxxxxxxx
Sent: Thu, 24 Jan 2008 6:07 am
Subject: Re: IML: Harmonic Balancer


Hi Paul, 
 
Ok, back to square one:) 
I want to pull the harmonic balancer for two reasons: 
 
a) The timingmarks are changing all the time on the old one, that means that the rubber has detoriated over the years and that the outer ring slips...  b) I want to replace the timingchain, I don't know how long the old one is in use (cause I don't know the maintainace history of the car), but I can hear that it is making noise (checked it with a stethoscope) 
 
Thanks, 
 
Robert 
----- Original Message ----- From: "PAUL WENTINK" <randalpark@xxxxxxx> 
To: <mailing-list@xxxxxxxxxxxxxxxx> 
Sent: Thursday, January 24, 2008 2:06 PM 
Subject: Re: IML: Harmonic Balancer 
 
Let's go back to square one. Why do you want to remove this? 
 
Paul W. 
 
-----Original Message----- 
From: Rob van der Es <r.vdes@xxxxxxxxxxxxxxx> 
To: mailing-list@xxxxxxxxxxxxxxxx 
Sent: Thu, 24 Jan 2008 12:01 am 
Subject: Re: IML: 59 413 engine color 
 
You might have a point here Rob! 
Same thing crossed my mind, but I was more thinking of breaking the 
head of the crankshaft bolt.. 
Leaving the remaining piece of the bolt flush with the 
crankshaft....oughhhh!!! 
 
Any thoughts, anyone? How is risky is that starter motor trick 
actually?? 
 
Thanks, 
 
Robert 
----- Original Message ----- From: "Rob Kidd" <rlkidd@xxxxxxxxxxxxxxxx> 
To: <mailing-list@xxxxxxxxxxxxxxxx> 
Sent: Wednesday, January 23, 2008 8:47 PM 
Subject: Re: IML: 59 413 engine color 
 
Sounds easy enough. BUT, what if the bolt was siezed in 
the crankshaft tighter than normal and you would shear a 
tooth on the starter or the ring gear since the engine 
would not normally turn over freely from a dead stop? 
Remember, 48+ year old "worn" parts you are dealing with. 
I'd try the impact route on the bolt if possible. Rob Kidd 
61/65 
 
On Wed, 23 Jan 2008 05:35:32 -0600 
"Stevan Miner" <miner@xxxxxxxxxxx> wrote: 
Sounds a little scary to me but if you do it this way, I'd certainly
>disconnect the coil wire to make absolutely no way the engine would >accidently start with the breaker bar in place. Stevan Miner Miner Auto >Service Winnebago, MN 
-------------------------------------------------- >From:
<mopar413@xxxxxxxxxxx> Sent: Tuesday, January 22, 2008 6:21 PM To: ><mailing-list@xxxxxxxxxxxxxxxx> Cc: "Dave Wilker"
<wilkerbeast01@xxxxxxxxxxx> Subject: Re: IML: 59 413 engine color 
Dave has the right idea. Just do like he says and make 
sure the socket is 
on right. Workd every time. for me. ---- Dave Wilker >>
<wilkerbeast01@xxxxxxxxxxx> wrote: 
I have a trick. I place the proper size socket on the 
harmonic balancer 
bolt, with appropriate extensions, and a good stout 
breaker bar. I turn 
the crank carefully until the breaker bar is resting on 
the left frame 
rail (driver's side). Once all the tools are firmly in 
place, I bump the 
starter. Just a bump. This breaks the bolt loose so you 
can remove it 
easily. Be careful when doing this. Make sure the 
socket is all the way 
on and there is no slack in the setup. David C. Wilker Jr. USAF >>>
(RET) ----- Original Message ----- >>> From: Rob van der Es To: >>> mailing-list@xxxxxxxxxxxxxxxx Sent: Tuesday, January 22, 2008 1:22 AM >>> Subject: Re: IML: 59 413 engine color Hi David, And, btw, do you have a >>> good trick to remove that 
bolt that keeps the 
harmonic balancer on the crankshaft? I am in progress of replacing
the >>> timing chain of my 
engine, but are a 
little afraid to start cause everyone told me that this bolt is
very >>> hard to remove.. Especially with the engine in the car, ofcourse I 
don't want to remove 
the engine for a relative "simple" job like replacing 
the timing chain!! 
 
Robert 
 
 
----------------- http://www.imperialclub.com ;
----------------- >> This message was sent to you by the Imperial
Mailing 
List. Please 
reply to mailing-list@xxxxxxxxxxxxxxxx and your response 
will be 
shared with everyone. Private messages (and attachments) 
for the 
Administrators should be sent to 
iml.webmonster@xxxxxxxxx 
To UN-SUBSCRIBE, go to 
http://imperialclub.com/unsubscribe.htm ;
 
----------------- http://www.imperialclub.com ----------------- >This
message was sent to you by the Imperial Mailing List. Please reply to >mailing-list@xxxxxxxxxxxxxxxx and your response will be shared with >everyone. Private messages (and attachments) for the Administrators should >be sent to iml.webmonster@xxxxxxxxx To UN-SUBSCRIBE, go to
http://imperialclub.com/unsubscribe.htm ;
 
----------------- http://www.imperialclub.com ----------------- This message was sent to you by the Imperial Mailing List. Please 
reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be 
shared with everyone. Private messages (and attachments) for the 
Administrators should be sent to iml.webmonster@xxxxxxxxx 
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm ;
 
----------------- http://www.imperialclub.com ----------------- This message was sent to you by the Imperial Mailing List. Please reply 
to mailing-list@xxxxxxxxxxxxxxxx and your response will be shared with 
everyone. Private messages (and attachments) for the 
Administrators should be sent to iml.webmonster@xxxxxxxxx 
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm ;
 
 
________________________________________________________________________ 

More new features than ever. Check out the new AOL Mail ! - 
http://webmail.aol.com ;
 
----------------- http://www.imperialclub.com ----------------- 
This message was sent to you by the Imperial Mailing List. Please 
reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be 
shared with everyone. Private messages (and attachments) for the 
Administrators should be sent to iml.webmonster@xxxxxxxxx 
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm ;
 
 
----------------- http://www.imperialclub.com ----------------- 
This message was sent to you by the Imperial Mailing List. Please reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be shared with everyone. Private messages (and attachments) for the 
Administrators should be sent to iml.webmonster@xxxxxxxxx 
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm ;
 


________________________________________________________________________
More new features than ever. Check out the new AOL Mail ! - http://webmail.aol.com

-----------------  http://www.imperialclub.com  -----------------
This message was sent to you by the Imperial Mailing List. Please
reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be
shared with everyone. Private messages (and attachments) for the
Administrators should be sent to iml.webmonster@xxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm



Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.