Re: [Chrysler300] Removing rear axles, 300H
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Chrysler300] Removing rear axles, 300H

Michael remove the axle key and then slip the dum on the axle loosely and then put the nut on and only tighten it about 3 threads and use the drum as slide hammer and pull the axle out. 
Ron Busenhart Santa Cruz Calf.
Sent from my iPad

On Nov 3, 2015, at 6:32 AM, Michael Moore mmoore8425@xxxxxxx [Chrysler300] <Chrysler300-noreply@xxxxxxxxxxxxxxx> wrote:


Can anyone suggest what tool to best use to remove the rear axles of this car once the rear hubs are off?
The factory manual suggests Chrysler tool C-319.
I am looking at slide hammers and how best to adapt to the 5/8-18 threads of the end of the axle
I have also read of using a pair of pry bars (?)

Thanks, Mike Moore


Posted by: Ronald Busenhart <RB1937ford@xxxxxxx>

To send a message to this group, send an email to:

To unsubscribe from this group, send an email to bob@xxxxxxxxxxxxx or
go to

For list server instructions, go to

For archives go to


Home Back to the Home of the Forward Look Network Archive Sitemap