Re: IML: 1959 Imperial Swivel Seat Problem with center arm rest
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: IML: 1959 Imperial Swivel Seat Problem with center arm rest



Hey, Ive had similar problems like that in the past, you might want to try a an elevater bolt, its very flat and will not hang up on nothing, they use them on conveyer belts when spliceing the enormous rubber belts together.  Jim  60 2drhdtp
----- Original Message -----
Sent: Thursday, April 19, 2007 9:00 PM
Subject: Re: IML: 1959 Imperial Swivel Seat Problem with center arm rest

I had this same problem on my 60. There is supposed to be a bolt there with an allen head slot. I THINK I got one from an armrest on a 63 that I was parting out.
John
----- Original Message -----
From: webmaster
Sent: Thursday, April 19, 2007 7:56 PM
Subject: IML: 1959 Imperial Swivel Seat Problem with center arm rest

I have a problem with the seats swiveling out all the way.  It seems like they only go half way and then hit a bolt in the center arm rest.  I think that the original bolt or screw has been replaced with a hex bolt that is just big enough to have the chrome inside rear corner bar strike the bolt.  Is this the case or do all of these seats act this way?  If I am in need of the replacing the hex screws who has a spare set to sell that is correct?


Steve Restelli
Webmaster:
http://BarreCity.net   
http://HistoryTV.net   
http://Zworykin.com    



Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.