Re: IML: '62 Imperial Brake "T" Distribution Blocks

[Kenyon Wills <imperialist1960@xxxxxxxxx>]

--- Joe Strickland <jwstrick426@xxxxxxxxxx> wrote:

> To the group;
> 
> I have done some preliminary searches on the web for
> the front brake "T" 
> distribution block, Chrysler P/N 2123 218 and the
> rear axle "T" junction 
> block, Chrysler P/N 2070 311.  So far I haven't
> spotted any available 
> from places like Andy Bernbaum etc.   Have any of
> you found a source for 
> these?
 
Each car has a stock brass block that the one MC line
goes into, and from which 2 fronts and one rear line
sprout.

Is this what you seek?  It is not a wear item unless
you cross thread it when you wrench on it every 20-30
years or so.

They are on every 1962 Imperial frame rail at Lowell &
Bob's.  Holding any old one against a wire wheel will
almost instantly make it new again.

If not this, then what are you trying to do?




-K



Kenyon Wills
 
 





















__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com 

-----------------  http://www.imperialclub.com  -----------------
This message was sent to you by the Imperial Mailing List. Please 
reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be 
shared with everyone. Private messages (and attachments) for the
Administrators should be sent to iml.webmonster@xxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm